ISO 60% acrylic case design
Posted: 18 Apr 2015, 04:18
I am looking to build a board with Alps, hand wired. I was looking at a standard 60% design (I attached the layout I found) and I was wondering if anyone knew a good resource for either making a design to have cut or premade ones. I likely will need both the plate and the case.
I can get it cut by a friend who has access to a laser cutter so that makes it a bit easier, but not sure how I would go about designing the case and plate.
This would be my first build, a lot of good resources on here, but I would also appreciate any general advice too.
I can get it cut by a friend who has access to a laser cutter so that makes it a bit easier, but not sure how I would go about designing the case and plate.
This would be my first build, a lot of good resources on here, but I would also appreciate any general advice too.