deskthority

I have a question for anyone who has tried these:

How do you remove them after you've installed them?

Is that the kind you put over a switch (which remains in place)?
I have some the same as in Muirium’s photo in this thread:



To remove them, I just insert a (very) small screwdriver on either side into the gap between the blocker I want to remove and its neighbours and then cautiously lift.

Okay, that makes sense.

Would be tricky if you put one over the Esc key spot though, yes?

Just tried that.
No problem, the gap around the blocker is still big enough.

Awesome. I may pick up a set some time.

Where did those white ones come from?

They are often to be found on Access-IS POS keyboards (which seem to only show up in the UK) and exist in white (rather a kind of light grey) and black.
How many would you want, and which colour?

Well, I have both white and black keyboards, so I'd want both white and black lockouts. I think 10 of each is all I'd need.

You could get 10 white blockers from me,
and I know Muirium has a black keyboard with them, but not whether he would be willing to dissect it

I can get black lockouts from Signature Plastics.

Good thing too. The only blockers I've got are the white ones pictured above. My Access board is fully populated with caps.