Page 1 of 1
My first Hand-Wired Keyboard Build
Posted: 08 Feb 2016, 23:40
by RevLinux
First off, thanks to all of you here for such GREAT informative posts. Without you I would never have been able to do this.
https://imgur.com/a/FJuFO
Posted: 09 Feb 2016, 22:12
by kristofv
First of all: looking good, congrats
Which diodes did you use? And which firmware did you flash to the teensy?
Posted: 09 Feb 2016, 22:54
by stuplarosa
Very nice.
Posted: 10 Feb 2016, 13:31
by RevLinux
kristofv wrote: First of all: looking good, congrats
Which diodes did you use? And which firmware did you flash to the teensy?
Thanks! It was a blast to build.
Diodes:
http://www.amazon.com/gp/product/B00UXPVLEG
Firmware:
https://github.com/tmk/tmk_keyboard
Posted: 10 Feb 2016, 13:52
by Muirium
Open bottom, eh? That's an idea! Where did you get that plate?
Got any plans to put something softer underneath, where it rests on the desk? I often put my 60%s right on top of my MacBook Pro so I'm forever wary of the feets!
Posted: 10 Feb 2016, 18:16
by RevLinux
Muirium wrote: Open bottom, eh? That's an idea! Where did you get that plate?
Got any plans to put something softer underneath, where it rests on the desk? I often put my 60%s right on top of my MacBook Pro so I'm forever wary of the feets!
I had the plates custom made, and there was a minimum order, so I have a box full of "spares."
https://www.reddit.com/r/mechmarket/com ... _w_paypal/
I never planned to put anything on the "feet" because I use a desk mat and it works great as it is, but I'm sure something could be done to keep the bare steel from the surface of a MacBook.