[WTB] IBM 3276/3278 Spacebar
Posted: 07 Nov 2021, 12:17
If anyone happens to have an intact space-bar for the 3276/8 beamspring model please reach out to me.
Page 1 of 1
Re: [WTB] IBM 3276/3278 Spacebar
Posted: 29 Nov 2021, 21:52
Hi, I might have something. Can you measure how wide it is so I can check?
Re: [WTB] IBM 3276/3278 Spacebar
Posted: 29 Nov 2021, 22:26
God damn that's amazing news! 
Going to send you the measurements in a sec
Going to send you the measurements in a sec
Re: [WTB] IBM 3276/3278 Spacebar
Posted: 29 Nov 2021, 22:30
Length is around 16.7cm (6.6inches) and width is around 1.8cm (0.7inches)ZyBeR wrote: 29 Nov 2021, 21:52 Hi, I might have something. Can you measure how wide it is so I can check?
Edit: this is measured on the bottom of the keycap as it's a bit smaller on the top, also could be a bit off.
Re: [WTB] IBM 3276/3278 Spacebar
Posted: 30 Nov 2021, 14:06
Would this work?
https://imgur.com/a/7cPo1x8
I bought a whole keyset a while back to get local alphas, but I haven't managed to find a beamspring.
https://imgur.com/a/7cPo1x8
I bought a whole keyset a while back to get local alphas, but I haven't managed to find a beamspring.
Re: [WTB] IBM 3276/3278 Spacebar
Posted: 30 Nov 2021, 15:46
Interesting, is this from a selectric or something similar?ZyBeR wrote: 30 Nov 2021, 14:06 Would this work?
https://imgur.com/a/7cPo1x8
I bought a whole keyset a while back to get local alphas, but I haven't managed to find a beamspring.
And there aren't any holes for a stabilizer right?