Hi again,
You guys were so helpful last time I've got 2 new questions! : ) Hopefully someone can assist again.
What's the optimal dimensions for the rectangular hole to fit costar stabilizers?
Does the actual stabilizer peg line up dead center of the stabilizer hole once everything is assembled?
Costar Stabilizer Plate Measurements
-
- Location: Stockholm, Sweden
- DT Pro Member: 0011
It is not straightforward. They holes should be somewhat offset to the centre of the switch, relative to the orientation of the switch.
I could draw you a diagram in QCad...
I could draw you a diagram in QCad...
- Toast
- Location: Canada
- Main keyboard: FC200r
- Main mouse: Logitech g400
- Favorite switch: Brown
- DT Pro Member: -
Oh! I was worried that might be the case. I'd appreciate it, or even a rough diagram as long as it shows exact measurements.
I appreciate as much accuracy as you can provide. : ) Will save me a good chunk of time and money for sure if they're dead on.
I appreciate as much accuracy as you can provide. : ) Will save me a good chunk of time and money for sure if they're dead on.
-
- Location: Stockholm, Sweden
- DT Pro Member: 0011
Here. I hope I got all the measurements right...