deskthority

Happy to hear that you fixed the issue! This was such an unusual error!

As I mentioned in the manual, on some keyboards the controller was not aligned correctly with the bottom inner assembly's ears and so it produced a short. The manual shows how you can push the controller back into place so ...

Another issue to check could be the grounding of the controller. Make sure both bolts are tight. I've seen odd behavior when these bolts are not tight enough.


I think we figured it out.... you are close, but doing the opposite ended up fixing it: loosening the 2 screws on the controller will ...

As noted in the manual, intermittent issues are sometimes due to dust or debris inside the keyboard, if replacing the springs and correctly reinstalling them does not fix the issue. The quickest way to fix this issue permanently would be to remove the keys and replace the springs and flippers with ...

Likely the springs and keys need to be adjusted and/or reinstalled or replaced because they are currently in the pressed down state. Sometimes a flipper gets stuck inside the barrel so you should make sure the spring can move freely, monitoring the signal level monitor utility screen for voltage ...

SOLVED 04/18/2025: Short somewhere in the controller, and loosing the screw just right will fix the issue. Also a bad solder on one of the 6 solders located right under where controler is mounted by 1 of the 2 screws. All ribbon solders look great, but the 6 solders right below the screw look to ...