Flashing TMK to Pro Micro for ADB converter
-
- Location: Canada
- Main keyboard: Focus FK-9000, heavily modded
- Main mouse: MX Master 3
Hi guys, I am building a converter for an M0116 and it seems I will have to use TMK. Physically building the converter is super easy (for me, anyway) but I am not quite sure how I should flash it. Is it as simple as with Soarer's firmware where I just download one .hex file and flash it with avrdude (I am running Manjaro Linux)? Or is there more to it? Thanks!
- abrahamstechnology
- Location: United States
- Main keyboard: Laser with SMK Cherry mount
- Main mouse: Mitsumi ECM-S3902
- Favorite switch: Alps and Alps clones
- DT Pro Member: 0212
I think you just download the hex file and flash it after shorting the pads to change the mode, (personally i've used Atmel FLIP)
-
- Location: Canada
- Main keyboard: Focus FK-9000, heavily modded
- Main mouse: MX Master 3
Where do I download the hex file? I skimmed the Github page (for the ADB converter) and it was talking about building one from scratch.abrahamstechnology wrote: ↑18 May 2020, 17:58I think you just download the hex file and flash it after shorting the pads to change the mode, (personally i've used Atmel FLIP)
-
- Location: Germany
- Main keyboard: Model F77
- Main mouse: Logitech MX Master 3S
- Favorite switch: Alpaca V2
You set your layout, generate the hex here and download and flash with AVRdude
http://www.tmk-kbd.com/tmk_keyboard/editor/
http://www.tmk-kbd.com/tmk_keyboard/editor/
-
- Location: Canada
- Main keyboard: Focus FK-9000, heavily modded
- Main mouse: MX Master 3
Awesome, will give it a shot, thankskmnov2017 wrote: ↑18 May 2020, 18:38You set your layout, generate the hex here and download and flash with AVRdude
http://www.tmk-kbd.com/tmk_keyboard/editor/
One question though, which pin on the Pro Micro is PD0? I think the Github guide is for a Teensy but I am not certain.
- swampangel
- Location: Canada
- Main keyboard: Northgate Omnikey 101
- DT Pro Member: -
Pin 2 on the pro micro is PD1, and pin 3 is PD0kelvinhall05 wrote: ↑18 May 2020, 18:40One question though, which pin on the Pro Micro is PD0? I think the Github guide is for a Teensy but I am not certain.