I built an ADB to USB converter using a pro micro and Hasu's firmware. I haven't yet soldered the switches back on to the board, but when I test it by shorting two pads together, hid_listen logs errors (and the keypress doesn't register):
Code: Select all
$ hid_listen
Waiting for device:
Listening:
Before init:
Scan: addr:2, reg3:6102
After init:
Scan: addr:2, reg3:6102
debug enabled.
Keyboard start.
adb_host_kbd_recv: ERROR(-217)
Before init:
Scan: addr:2, reg3:6102
After init:
Scan: addr:2, reg3:6102
debug enabled.
adb_host_kbd_recv: ERROR(-89)
Before init:
Scan: addr:2, reg3:6102
After init:
Scan: addr:2, reg3:6102
debug enabled.
I'm starting to run out of ideas, and was wondering if anyone had any tips? I was thinking that if all else fails I could try to figure out the matrix layout and hook up a Soarer's controller.
Here are a couple of photos of the board: