However the xwhatsit has been redesigned so I am not sure where to solder the wires anymore as I was going to use the above picture as a reference.
![Image](https://www.modelfkeyboards.com/wp-content/uploads/2015/12/2020-06-24_21-39-47.jpg)
Anybody know the correct locations for soldering with this new design?
So I just solder the wires into any test point I want and program it later? Seems strange but I have no idea about these things. I know there are traces from the front and back of the sensing circuit. What is the program I need to use to do that?
That is awesome, thank you!Muirium wrote: ↑10 Feb 2023, 09:35This will explain it better than I can. Thoroughly worth the read:
https://static.wongcornall.com/ibm-caps ... odel_f.pdf
That’s Xwhatsit’s excellent documentation for his firmware which is what all these controllers were originally built for. Other (in certain areas better) firmwares are available now, but for ease of learning his may be the best place to start.