Dell AT101W Diodes
-
abrahamstechnology
- Location: United States
- Main keyboard: Laser with SMK Cherry mount
- Main mouse: Mitsumi ECM-S3902
- Favorite switch: Alps and Alps clones
- DT Pro Member: 0212
Hi, as some of you know, I'm modding a Dell AT101W. On the PCB, there are lots of jumpers. I'm wondering if I can improve the board's rollover by replacing some of them with diodes. Has anyone mapped out this PCB, so I can put the diodes in correctly? Thanks.
-
Hak Foo
- Location: US
- Main keyboard: Omnikey 102 Blackheart
- Main mouse: Kensington Expert Mouse
- Favorite switch: White Alps
- DT Pro Member: 0174
The problem is that the controller would have to know about the diodes; it's unlikely they programmed it to expect them,
IYou'd probably have to replace the controller with a Teensy or similar, and run custom firmware. At that point, you can design whatever matrix you want.
IYou'd probably have to replace the controller with a Teensy or similar, and run custom firmware. At that point, you can design whatever matrix you want.