Almost done with my first pcb design! Looking for someone to check it
-
eatyo
- Location: United States
- Favorite switch: cherry brown
- DT Pro Member: -
So I just about finished my first custom pcb design. I am new at this so I was hoping someone here with more experience could look it over and let me know if everything checks out. I am planning on using the teensy as my controller, I used pins 25-30 of the pins for the rows and the pins 13-23 and 32-39 for the columns. For reference this is the intended layout http://www.keyboard-layout-editor.com/# ... 753f5721e2. Thank you in advance!
- Attachments
-
- pcb_bottom.pdf
- (618.06 KiB) Downloaded 76 times
-
- pcb_top.pdf
- (645.34 KiB) Downloaded 78 times
-
- pcb_all.pdf
- (824.8 KiB) Downloaded 70 times
-
- schematic.pdf
- (158.93 KiB) Downloaded 71 times
-
zool
- Location: Melbourne
- DT Pro Member: -
looking good, i like the layout. I didn't check everything but it looks about right, bottom trace coming off B looks like it might clip a pad, i would not fork your traces as you have space to route them normally with a little work, the fill is a little funky in spots i'd also throw in some pull ups/downs, don't have to use em, but handy if the internals are a bit weak. also give your self some more room on the edge of the board at least a 1mm or 2 (especially top layer under the nav cluster) pull the fill back from your mounting hole a bit or make sure they are all gnd. also looks like you might be missing stabs for numpad + and enter.